This is what the debug window looks like:.you should see a white window with a text entry box at the bottom:.then again in Bitcoin Core, go to "Help" > "Debug Window", then click the "Console" tab.This is what the scriptPubKey looks like after you’ve pasted it into the scratch pad:. Copy this to your scratch file along with the what vout your output was. Under the scriptPubKey section, there is a "hex" section. Under the correct vout section (0 or 1 usually) in the JSON viewer look for "scriptPubKey". If it was the second one, then your vout is 1 (the numbering is zero-based). If the output with your address and bitcoin amount was the first one listed in the transaction, then your vout is 0. Remember the vout index number is the one from the screenshot of the Insight Block Explorer above. Look for the vout number (0 or 1 usually). The resulting output in the right pane is what you want.This is what looks like after you’ve pasted in the url for :.click the button that says "load url" and put in: where txid is your transaction id.Now, we need to get a piece of data from the internet about your last transaction. Also note which output in the transaction has your funds and the amount of bitcoin in the scratch file (see the screenshot above) copy and paste the transaction id of the transaction that has your unspent funds into your scratch file.if you found an address from your receiving window that has unspent funds, then proceed.The following screenshot will show you what an unspent transaction output looks like: A spent output has another bitcoin transaction that came later that used that output as an input. Note, that the "(U)" means "Unspent" and "(S)" means "Spent". Unspent transactions is money that was sent to you that you haven't re-spent to someone else. Paste each address into Insight to see if there are any unspent transactions to it. This is what the “Receive” section of Bitcoin Core looks like:.You want to double click on each entry, then click "copy address". Those addresses might show up as "Recent payments history". find the address that had funds sent to it, you might only have a few addresses under the "Receive" section of Bitcoin Core.open Bitcoin Core (it is ok if it is not sync'ed).This is what a receiving address from BitPay’s Copay looks like:.It is essential that this address be a receiving address from your NEW wallet cut and paste a RECEIVING address from your new wallet.open a blank text file (in Notepad or TextEdit), we will be using this as a scratch pad.install a new wallet of choice, we recommend BitPay wallet, Electrum, or even.Open the debug console inside Bitcoin Core.Install a new bitcoin wallet (like BitPay ).You don't want to wait for a full synchronization of the blockchain before transferring your funds.Either because it takes a better part of a week to sync the blockchain or you just don't like the wallet. You've sent funds to a Bitcoin Core receiving address and then discovered that Bitcoin Core is NOT the wallet that you really want to use.This is a bit advanced but if you follow the directions carefully, anyone can do this: Principles:
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |